Plastics. Acquisition and presentation of comparable single-point data - Long-fibre-reinforced plastics1 Scope ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers'

By defining open containers for image

— eluates of industrial waste

BS EN IEC 62660‑1:2019 edition constitutes a technical revision which are as following-

BS EN IEC 63135 specifies the minimum operational and performance requirements

and human life

BS 7160 applies to anchor chains of nominal diameters between 6 and 12 mm

whereby time-compressed fatigue simulation in particular has to be considered for the determination of the test intensity

Are there other considerations

• manufacturer’s requirements including user information

and application of installed equipment for monitoring local gamma radiation dose rates within nuclear facilities during normal operation and anticipated operational occurrences

Who is BS EN 15618 - Upholstery fabrics - Classification and methods of test for

This document provides general considerations to support the guidance to geotechnical and civil engineers for design using geosynthetics provided in the subsequent parts of the ISO/TR 18228 series