Founding. Ausferritic spheroidal graphite cast irons. ClassificationWhat is ISO 17804 about? ISO 17804 defines the grades and the corresponding requirements for ausferritic spheroidal graphite cast irons. ISO 17804 specifies five grades of ausferritic spheroidal graphite cast iron by a classification based on mechanical properties determined on machined test pieces prepared from: Separately cast samples, side by side cast, or cast on samples Samples cut from a casting ISO 17804 also specifies two grades by

NOTE 1: This document is intended to be used for managing physical assets in particular

the following modifications have been made in BS EN 14358:2016:

The purpose of PD IEC/TS 62916 is to establish a common and reproducible test method for determining diode surge voltage tolerance consistent with an electrostatic discharge event during the manufacturing

It supplies an up-to-date and authoritative source of safety information in an area where the HSE reports that two or three operators are killed every year

BS EN ISO 15614-8 has been systematically reviewed by experts

This is a revision of the 2004 edition

ovens and similar appliances for household use

maintenance and overhaul industries

This document establishes the specifications for the execution of dynamic load tests in which a single pile is subject to an axial dynamic load in compression

Implementation of Change Requests

from an inter-laboratory test or test codes such as EN 16703 and EN 12758

Emergency planning committee