Wiegand Keypad RFID Reader compatible with EM 125kHzWiegand Keypad RFID Reader compatible with EM 125kHz Cards. Control wires available for LED (Change from blue to green) and Buzzer control. Maximum ID length of 12 digits can be keyed in and sent by hitting the 'ENT' key. The ID can be cleared out to start over by hitting the 'ESC' key. 6 pin connector is added to the reader for pairing with: HTD 008 A: 1 Wire Output Conversion Cable, DC to DC converter, Power Enable, LED and Buzzer Control HTD 009 A:

Equivalent cable for 5C610

the cable will also provide the following features:

Temp Probe 1 in chain requires cable SKU: HTC-007 to connect Ground and 1-Wire communication

The RS232 Serial Output Cable models will work with all of our Wiegand output readers:

and sends the ID to a 1-Wire interface utilizing iButton protocol

Cable is 1-meter in length with connections populated for Power

Each part of the cable is 1 ft

9-pin Type II j1939 connector to DSUB 15-pin connector for CalAmp jPOD devices

Writable: The card comes with no defined ID

and Ground

Cable provides three 9-pin j1939 Type 2 connectors that allow a device to be connected to the vehicle

Software for the HTA-003 can be downloaded here