EDWARDS EST SIGA-CC1S Sync ModuleThe SIGA CC1S Auto Sync Output Module is an addressable module that is used to connect the following circuits: Audible and visible notification appliance circuits (synchronized or unsynchronized) Speaker circuits Two way telephone communication circuits (three state or four state) Upon command from the loop controller, the module connects the riser to the output circuit. The module requires one address on the signaling line circuit (SLC). Addresses

This device is compatible with several Simplex systems including 4006

In other words

and 5820XL-EVS IntelliKnight® addressable fire alarm control panels programmed for System Sensor protocol

These multi-candela strobes come synchronized over a two-wire circuit when connected to compatible NACs

The 270A Series Manual Stations have 6 inches (150mm) wire leads

Reduces installation time with accessible wiring terminals

The Gamewell-FCI

microprocessor-based signal processing

and thanks to an ingenious full backplane sealing gasket

Built-in Digital and IP communicator

Wheelock Power Supplies or other manufacturers panels incorporating the Wheelock Patented Sync Protocol

4 oz (68 g)