Geographic information. Conformance and testing1 Scope This International Standard specifies the framework, concepts and methodology for testing and criteria to be achieved to claim conformance to the family of ISO geographic information standards. It provides a framework for specifying abstract test suites (ATS) and for defining the procedures to be followed during conformance testing. Conformance may be claimed for data or software products or services or by specifications including any profile

This standard establishes uniform requirements for the following:

This part of ISO/TS 7849 gives basic requirements for a reproducible method for the determination of the sound power level of the noise emitted by machinery or equipment by using surface vibration measurements

It uses the four-figure numerical and the alternative chemical symbol based alloy designation systems specified respectively in BS EN 573-1 and BS EN 573-2

BS EN 2591-403 on aerospace series is applicable to:

as well as graphs in standards

It is designed to determine at the material level if the edge seal can keep moisture out

9 specifies the A-chain electrical frequency response characteristic for photographic sound reproduction in motion-picture control rooms and indoor theatres

The connectors connect a backplane to printed boards

BS EN 4808 is one of a series of documents applicable to the specifications of straight welded coupling in nickel alloy

“Crown closure” and “crown cork” replaced by “crown cap”

This document defines general terms used to describe external limb prostheses and orthoses

based on the same chemistry