Snow soldier armorThis bad boy is made up of 38 individual pieces (not counting the helmet!), and as always, Ive sprinkled in some upgrades to make the builds better and better. Heres the juicy rundown: Backpack: Lightweight and hollow for access to straps, harness, or screwing in whatever you need to carry this one on your back. Plus, its pre split for small printers ! Chest Piece: Once again you can pick from regular, pre split version with separated details for a

The little aim helper is also removable

- Motorized wrist laser

which I’m calling The Harvester

Now this was very extensive

it is best suited for resin printing

-Motorized helmet faceplate

Despite these challenges

I have fully printed this suit and tested it myself

2011 Thunder God Helmet 3D Printable Model

a full version and a split version for printing separately colored pieces

To make that part easier I added a pre-supported version as well

I still remember the first time I saw it in the movie—it just looked so badass