End mill holder Weldon BT 50 - 40 - 110Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Chrome molybdenum steel ( or Chrome vanadium steel ) square drive

Further information on the articles included can be found under the respective article number

For retaining screw DIN 6367

Enables reduction to the next smallest insert holder

360° graduations for angular adjustment

Ground internally and externally

quick and simple measuring of the clamping force of hydraulic chucks

DIN 1835 form A+B+E and DIN 6535 form HB+HE (larger than Ø 20 mm only with reduction sleeve)

For use on vises

Satin chrome finished

One turning toolholder - four possibilities:

Sealing capacity up to 80 bar