Wishbone Stud for Bearing Carrier, TitaniumHyper Racing # 72 010 Our H Mark Wishbone Stud just made mounting your wishbones a whole lot easier. Built in shoulder provides an increased misalignment angle to help prevent binding of the wishbones rod ends. The machined in washer prevents gouging of the bearing carrier by the hex. Made from the highest quality 6AL4V Titanium for maximum strength and weight reduction. During the manufacturing process of the wishbones, welding tension will cause

HBS Styling

Slight offset

Hyper Racing # 382-981

Hyper Racing # 604-505

25-545 aluminum dust caps

its effective spring rate is progressively increased

23 inches long

Vented titanium piston will reduce heat build up and heat transfer to the brake fluid

250" diameter pistons

email mike@hyperracing

5/2 valving

A bump rubber can also be used on the left rear of a wingless car to add traction on corner exit