Sway Bar Kit With Bushings, Front (SB038) And Rear (SB033)The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB039 front and rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy wall

9 hardware included

These springs will drop your 1967-1972 GM A-body 2-inch

BMR Suspensions KM007-1 K-Member is available in black hammertone and red powdercoat for long-lasting good looks

BMR's AA001 Upper A-arms come with new upper ball joints

This item allows for easy bolt-on installation with no drilling required

the Driveshaft Tunnel Brace reduces floor and driveshaft tunnel deflection with no change in NVH

API Service Class GL-4

and comfort

may not fit aftermarket rear ends

the Cradle Bushing Lockout Kit minimized bushing and cradle deflection with nearly no change in NVH

giving you the ultimate is strength and reliability

along with trailing arm adjustment for fine-tuning the instant center