1JZ / 2JZ Yaris Coil Pack KitThis conversion kit is for Toyota Yaris coil packs installed on 1JZ non VVT i engine. The kit is recommended to be used with Bosch Ignition coil 0 986 AG0 502, BIC729 or Toyota OEM. This kit retains the factory crossover breathers that run between both cam covers. This kit is suitable for 1JZ non VVTi, 2JZ non VVTi and VVTi GTE variants but not yet tested on 1JZ VVTi (if the OEM bolt holes are the same then should fit also). The kit will also fit 2JZ

These fittings are a push in direct replacement of the OEM barb fittings so there is no need to drill and tap new fittings

2x AN6 Male Fittings

belt and wiring are not included

Wait for sealant recommended amount of time before filling up with coolant and running the motor

1x Billet cover

The CKS Lab MA61 Drive By Wire Accelerator Pedal Kit bolts to the firewall allowing a Hilux pedal to be used as the pedal sensor for DBW setups

reuse original bolts)

The Hilux pedal provides the advantage of running a DBW setup but also keeping the OEM look and feel of a cable pedal

you may need to grind the corners of the kit so that it doesn't touch)

apply Welsh plug sealant then gently tap fitting in with soft faced hammer or with wood in between hammer and fitting

6x m6 x 25mm bolts

The result is more efficient cooling and lower coolant temps