Alpha HSS Tap UNC Bottoming 1/2x13 UNCHB12BOTTOMING taps have a lead of two threads and are used when tapping blind holes. Usually preceded by a taper or intermediate tap. Alpha bottoming taps can be identified by their plain shaft, they have no rings on the shaft near the driving square. Diameter: 1 2mm Pitch: 13mm Overall length: 75mm Shaft Diameter: 9mm Drive Square: 7mm Tapping Drill Size: 10. 75mm Weight (gr) 50. 00

LOCTITE® SI 5699 is a flexible silicone sealant and cures on exposure to moisture in the air to form a tough rubber gasket

Universal instant adhesive gelWill not drip or runPerfect for all quick repairsIdeal for overhead application and vertical facesNon-wicking

zippers and pulleys and as a mould release for plastics and composites

Stainless Steel Screws and Nut Set 6mm x 16mm- Contains 10 x Nuts and 10 Screws-

Weight (gr)    10

Self-starting split point removes the need for a pilot hole

non-staining and odourless

Weight (gr)    49

Set comprises 1 each - taper

CRC Wire Rope and Cable Lubricant also contains a tackifier that enables the lubricant to cling tenaciously to metal surfaces without increasing the viscosity

Width (mm)    80

Loctite 510 is a high temperature resistant anaerobic sealant which cures when confined in the absence of air between close-fitting metal surfaces