Four prong drive MT2 lot 544

This jig fits onto lathes with a center height of between 125mm (10" swing)  to 280mm (22" swing)

The tool comes with a torx key and round bar tip holder for sharpening the tip

fresh abrasive is exposed to ensure a sharp cut every time

this piece is 149mm diameter by 46mm thick

although this does fade after a while

coffee tables

12mm thick

For a water resistant finish use Liberon Finishing Oil applied with a lint-free cloth or Ultra Fine Steel Wool (0000)

INCLUDES 16MM CUTTER

1 x Komelon Stick Flat Tape Measure 1m (Width 13mm) (Metric only)

and non-flammable

Finishing Oil is our version of Danish Oil* and uses Tung Oil as its base but with the addition of solvents and driers