Connectors for electronic equipment. Product requirements - Generic specification1 General 1. 1 Scope This part of IEC 61076 establishes uniform specifications and technical information for connectors. This part of IEC 61076 is applicable to a family of connectors for use in electronic and electrical equipment; connectors designed for use at radio frequencies are not covered.

The conditions described in this European Standard do not necessarily always correspond to the optimal conditions allowing the maximum degree of biodegradation to occur

Who is ISO 11990 - Determination of laser resistance of tracheal tube shaft and tracheal cuffs   for

2 application to radiographic cassettes with an integrated anti-scatter grid may not give satisfactory results

Compliance with BS EN 60811-603 can benefit you by providing different properties and test methods to demonstrate their quality providing protection against corrosion and potential dielectric problems

– standardized

Mobile AIDC services refer to consumer-oriented information services provided via telecommunication networks and triggered by AIDC technologies such as RFID

NOTE Where the lining or drape is separate from the outer fabric

Consideration is also given to other traffic and pedestrians

and the method of estimating the phase ripple from the measurement result of GDR are shown in BS EN 61300-3-38

Sampling volume

It covers protective clothing mainly for the protection of the operator

The requirements and test methods provided by BS EN 1497 assist you in improving the performance and quality of rescue harnesses