Shell mill holder SK 40 - 27 - 40Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

Slides hardened and grinded

5 x 58 x 18

5V AA Batteries * 3 ( Do not use low self-discharge battery )

102 x 40 x 21

In the tailstock of the lathe so that no friction occurs between the workpiece and the tip

clamping depth 2 mm

Minimum internal diameter measurement capability of:

bei Ø 6 – Ø 32 mm = h236

Application:

Test certificate

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

Adaptive interface machine direction (ADINTMS): BMT driven turret interface -size BT65A