Rubber hoses and tubing for air and vacuum systems for internal-combustion engines. Specification1 Scope This International Standard specifies requirements for rubber hoses and tubing for use in the various air and vacuum systems found on internalcombustion engines. The standard does not cover hoses used for direct power brake actuation in trucks and trailers, nor for air intakes and ducting within the passenger compartment. The highest temperature hoses are generally used for turbocharger applications. All hoses and tubing remain serviceable

particular recommendations are given for reinforced concrete

nozzles and Venturi tubes) when they are inserted into a circular cross-section conduit running full

Systems that are designed for continuous condensation within the flue system under normal operating conditions

Who is BS EN 4359 - Drivers for six lobe recess internal drive for

mechanical construction and electrical construction

the Department of Homeland Security (DHS) selected BS 25999-1 and BS 25999-2 as standards authorized for use in the Voluntary Private Sector Preparedness Accreditation and Certification Program (PS-Prep)

Who is PD IEC/PAS 61249-8-5- Permanent solder masks and flexible cover materials for

Who is BS EN 3856 – Characteristics of swivel nuts for thrust wire for

The following requirements are addressed in this document:

BS 1804-2 on metric series parallel steel dowel pins is useful for organizations that design

Procedure for preparing YCT

but are not necessarily environmental experts