Resilient floor coverings. Polyvinyl chloride floor coverings for use in special wet areas. Specification1 Scope This European standard specifies the minimum additional characteristics which are necessary for: polyvinyl chloride floor coverings in roll form according to EN ISO 10581 or EN ISO 10582, polyvinyl chloride floor coverings with foam backing in roll form to EN 651, polyvinyl chloride floor coverings with particle based enhanced slip resistance in roll form to EN 13845 to be installed satisfactorily in special wet areas to form a watertight

This European Standard applies to large transportable vacuum insulated cryogenic vessels for fluids specified in EN 13530‑1:2002 and does not apply to vessels designed for toxic fluids

coaxial connectors with screw lock

If a surface or near-surface flaw is present

The shape factor of the test piece is important and comparative test results can only be obtained on test pieces having the same shape factor

introduced into wood treated previously by full impregnation

BS EN 3373-002 provides you with all product standards which specifies standards for terminal lugs and in-line splices for crimping on electric conductors

Radiologists

Trace heating is accomplished by attaching specially designed cables made of a resistance element to the pipe or vessel

and identifies areas where there are barriers to standardisation

mineral matter free basis (see Part 16 of this standard)

Smaller minimum creepage distances for printed wiring boards and equivalent constructions under pollution degree 3 than those specified in Table F

Protection of the environment needs to be considered during the total life-cycle of a particular product