Ground granulated blast furnace slag for use in concrete, mortar and grout - Definitions, specifications and conformity criteria1 Scope This European Standard specifies requirements for the chemical and physical properties as well as quality control procedures for ground granulated blastfurnace slag for use as a type II addition in the production of concrete, including in particular cast in situ or prefabricated structural concrete conforming to EN 2061. Ground granulated blastfurnace slag conforming to this European Standard may also be used in mortars and grouts. Ground

Track components

3 Measurement procedure

two essential series of parameters have been considered

BS EN 843-2 is your guide on determining whether the monolithic ceramics are fit for purpose

The BS EN 61508 series consists of 7 parts that cover the functional safety of E/E/PE safety systems:

Hence BS EN 3709 walks you through the requirements to be complied with by wrenches and double-hex sockets intended for aerospace products

BS EN 1434-3 specifies the data exchange between a heat meter and a readout device (POINT / POINT communication)

It describes methods for the calibration of equipment and the preparation of test samples

EN ISO 9606-5

11:1993 (BS ISO 5667-11:1993) and BS ISO 5667-18:2001

Determining the dimensions and loads of rod ends can be difficult and complex

It gives a general introduction into European Space Standards and their use in space programmes and projects