Milling arbors for screw-in cutters SK 40 - M16 - 44 - LB25Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Ø 6 – Ø 32 with h6-tolerance

Vorschub (Empfehlung): 3

PSC to PSC adapter with axial clamping

Clamping accuracy at the centre 0

- Stainless steel 1

Clamping possible on both sides

For mounting straight-shank tools in collet chucks DIN 6391

Minimum internal diameter measurement capability of 20mm

Sealing capacity up to 80 bar

Spring mounted spherical tip protects the unit from damage if contact is too strong

prevents overfeeding

With coolant channels for optimal coolant at the cutting edge