Technical drawings. General principles of presentation - Basic conventions for representing areas on cuts and sections1 Scope This part of ISO 128 specifies general principles for representing areas on cuts and sections on technical drawings (mechanical, electrical, architectural, civil engineering etc.) following the orthographic projection methods specified in ISO 5456 2. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128 40[1].

It is intended that the specification allow system OEMs and peripheral developers adequate room for product versatility and market differentiation without the burden of carrying obsolete interfaces or losing compatibility

Cableway installation engineers

requirements specified and extended

— risk assessment of nanomaterials in the context of medical device evaluation

Details of any sample pretreatment

This International Standard is not applicable to compression moulds or injection moulds

which is covered by BS EN 1153:1996

BS 8591 thus ensures that communication between telephone exchange and remote centres is well-maintained for timely risk and hazard identification

Annex H gives a test for shrinkage of oversheath on cable

BS EN 62717 on LED modules for general lighting is for:

Who is BS EN 14187-3 - Self-levelling properties of cold applied joint sealants for

Addition of specific applications