Hexalobular socket raised countersunk head screws1 Scope This International Standard specifies the characteristics of hexalobular socket raised countersunk head screws of product grade A, and with thread sizes from M2 up to and including M10. If, in special cases, specifications other than those listed in this International Standard are required, they can be selected from existing International Standards, for example ISO 261, ISO 888, ISO 898 1, ISO 965 2, ISO 3506 1 and ISO 4759 1.

a) absorption capacity and effectiveness of grouting in rock mass

3 Welding filter with automatic scale number setting

It provides an understanding of the meaning

Who is BS EN 13648-1 - Safety valves for cryogenic service for

The thimbles are intended to be used in slings made with six or eight strand steel wire ropes from 8 mm to 60 mm diameter complying with EN 12385-4

and requires clear marking of types of flammable gases which can be measured by the portable gas detectors

This European Standard specifies requirements for elastomeric materials used in seals for supply pipes and fittings

The stages of the life cycle that are considered are

NOTE These telephones are excluded because they were under development during the elaboration of this document so that their specifications remained to be determined

ISO 15708‑4 deals with computed axial tomography and excludes other types of tomography such as translational tomography and tomosynthesis

Methods and units of measurement

— "particular requirements"