1968 Chevrolet Camaro 302CID-290HP 4bbl Holley Dual-Feed 3/8", 5/16" Pump to Carb Lines 3pc, OE SteelThese preformed engine lines will replace the original pump to carburetor fuel lines and run from the fuel pump to the carburetor following factory routing. Our replacement lines are engineered from factory original lines, CNC manufactured for precision, and include the correct fittings and flares (where equipped). Please note that these lines are intended to work with factory fuel pumps, carburetors, and intake manifolds.

This pre-fabricated tube has a 90-degree bend on one end and is 60” in total length including the 3/8” tube and 5/8”-18 fittings

1964-87 GM A-Body G-Body 1970-81 F-Body 1968-79 X-Body Front Sway Bar Bracket Rubber Inserts 1-1/8" 2pc

1970-72 Cutlass Hardtop & Convertible Tail Panel Trunk Wiring Harness 1pc

and intake manifolds

Complete Front & Rear Hose Kit

1968-72 Oldsmobile Cutlass 442 Accelerator Plate

This kit includes two 18” hoses: one with a 9/16”-18 male end and a 7/16”-24 male end

and straightening tools can be found in the related products section below or by choosing the appropriate category in the main navigation bar above

1967-70 GM A-body X-Body Chrome Center Cap "SS 396" 4pc

1964-74 GM 5/16" Upper Ball Joint Rivets

This is for cars with factory 4 piston Disc Brakes

1964-72 GM A-Body Upper Arm Cross Shaft End Bolts & Black Phosphate Washers 12pc