TP-Link Omada OC-200 Rack Mount (Modular)3D Printed 1RU rack mount for the TP Link Omada Controller (OC 200). This is part of our ModMount Range, so you can mix and match your parts! This item is Omni directional, so you can use it on the left or right side. NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width, screws are included to join the parts. The OC200 slides into the frame from the front. This listing is just for the Mount,

The device slides into the mount from the front and cables are accessible from the rear

3D Printed rack mount that lets you mount your Unifi Enterprise (Or Professional

The MS-01 or MS-A2 slides into the frame from the rear and is securely held in place with a rear bracket

The Switch slides into the frame from the front

then we recommend using 12mm M2

3D Printed rack mounted Shelf for 10 Inch Racks

The screws to fasten the Raspberry PI's to the trays are NOT INCLUDED

Screws are included to join the parts

The Router slides into the frame from the front and can have its ports either facing to the front or back

NOTE: You will need to pair this with another ModMount item (Like some Blanking Plate) to make a full 1RU Width

This mount also incorporates a pair of Keystone Sockets so you can use Keystone Jacks and Fly leads (Optional Extra) to re-route ports to the faceplate

5 12mm Screws (Not included) to secure the rPi to the tray