Fine Feed for Milling machine PF 230 and Micro Miller FF 230Easily installed in a few seconds. The feed may be used via either the height feed (vertical) or the fine feed in the tilted position. The graduated scale may be zero reset. One revolution is equivalent to 1. 5mm spindle travel (1 division = 0. 05mm).

taper turning

Ball-bearing shaft end on machine

powder coated

All-rounder on 3 levels

Material for the motor-vehicle repair kit

Stable head of die-cast zinc for precise fitting

Bevelled edges at the front and back allow slight cleaning

An acoustic and visual signal warns the user when temperature exceeds or falls below the permissible limit

non-ferrous metals and stainless steel surfaces

Ideal for working on surfaces in recesses

clean planing of soft and hard woods

Ball and socket: rotates in all directions (even downwards)