Plastics. Injection moulding of test specimens of thermoplastic materials - Preparation of standard specimens for investigating anisotropy1 Scope This document specifies a mould (designated the type F ISO mould) for the injection moulding of plates with a preferred size of 80 mm 120 mm and a minimum size of 80 mm 90 mm and with a preferred thickness of 2 mm for single point and multi point data acquisition. It has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection. Whenever possible, a two cavity mould is intended to be

The method specified under BS EN 15634‑2 has been validated on emulsion-type sausages (Bavarian “Leberkäse”) spiked with celery

BS EN 50393:2015 will be of most relevance to:

although one EPB standard may cover more than one module and one module may be covered by more than one EPB standard

or polymers

BS EN 1593 describes procedures for the detection and location of leaks by the bubble emission techniques

or the isolation of

Induced voltage tests are now based on Ur rather than Um and New requirements for impulse waveshape (k factor) have been introduced

This standard does not specify requirements for applications

when towing trailers

inter-harmonics up to the 50th harmonic

Test methods for the determination of the properties of non-crosslinked epoxy resins are not included in this part of ISO 3673

They are designated by B