Metallic powders. Determination of apparent density - Funnel method1 Scope This document specifies the funnel method for the determination of the apparent density of metallic powders under standardized conditions. The method is intended for metallic powders that flow freely through a 2,5 mm diameter orifice. It can, however, be used for powders that flow with difficulty through a 2,5 mm diameter orifice but flow through a 5 mm diameter orifice. Methods for the determination of the apparent density of powders that

For reflectance and transmittance values outside these ranges ISO 52022-3 applies

BS EN 62220-1-1 is not applicable to:

The maximum capacities of the various types of tank are specified

BS EN 448:2009 applies only to insulated fitting assemblies and single use compensators for continuous operation with hot water at various temperatures in accordance with BS EN 253:2009

Two preparation methods are described in this test method:

If it is applied to other fabrics such as linen or regenerated cellulosic fibres

BS EN 60297-3-106 discusses arrangement overview and definitions that depict a user-friendly idea of subracks and chassis

which should then be used for quality score normalization

This part of ISO 5361 specifies general requirements for Cole tubes for use in infants

or semi-trailers or other load-handling means applicable for container handling

Manufacturers of heat-resisting alloy wires

It is recommended that bias be applied during time track code recording