Hydraulic expansion chuck HSK 100 - 16 - 150Application: For mounting straight shank tools acc. DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia. 20 mm only with reduction sleeve). Note: l1 = max. clamping depth l2 = max. length adjustment range Delivery: Without wrench All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile

Flute geometry with special design

Hardened and grinded all around

For gauge-accurate working and controlling

For mounting straight-shank tools in collet chucks ISO 15488 (ex

vertical and lateral

With securing screws and Tee-nuts

Clamping possible on both sides

chip breaking

Eingebauter Niederzug

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance

A possible increase of axial force during the tapping process is reduced to a minimum

With retaining screw