Milling arbors for screw-in cutters SK 40 - M16 - 24 - LB5Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Warranty card

Quick release function

clamping depth = 41

Suitable for internal coolant

Clamping possible on both sides

Suitable for mass production

load capacity 200kg

Protection level IP65

Sealing capacity up to 80 bar

bei Ø 6 – Ø 32 mm = h238

For the chucking of quick change adaptors for taps

E1= 20 pieces