ER-Collet with cooling channel holes ER16 | 426EC | < 15µm | Ø 5Application: For mounting straight shank tools in collet chucks DIN 6499. Note: Only nominal size d can be clamped, with cooling channels. In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet. (applicable up to 21 bar)

Further information on the articles included can be found under the respective article number

Accuracy according to DIN 875

(applicable up to 21 bar)

5V AA Batteries * 3 ( Do not use low self-discharge battery )

vertical and lateral

Instructions for use

Carbide tipped measuring faces

so the system is suitable for through-coolant feed

Mode : Peak

T-nuts 18 mm

- four measuring methode: standard

- in case/box