Pipework. Stripwound metal hoses and hose assemblies1 Scope This International Standard specifies the requirements for the design, manufacture and testing of four principal types of stripwound metal hose and hose assemblies, of which only one type is for pressure applications. The four are: single overlap, unpacked and packed; double overlap, unpacked and packed, the last of these having maximum allowable pressures of up to 40 bar. These hoses and hose assemblies may be supplied in nominal sizes from

ISO 21041 assists in increasing consumer satisfaction

5 kHz to transmit information on low voltage electrical systems

It does not include requirements for the durability of upholstery materials or the durability of mechanisms as used in convertible sofa beds

EN ISO 15610

you can design and manufacture good quality Camera tubes used in electronic components

Annex B (informative) Durability and recycling

The guidelines in BS EN 3475-301

as it contributes to controlling the quality

11 Response

modal interchanges

9 Requirements for non load-bearing boards for use in humid conditions (Type P3)

BS 5867-2:1980