Shrink chuck 4,5° BT 50 - 06 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For adaption from ISO40 to PSC (ISO 7388-1 to ISO 26623-1)

sleeves and tool arbors

maximum = 50 mm)

Axial sealed with two O-rings

clamping depth = 47

the control lamp lights up = identification of the reference point

- Especially suitable fore wire EDM

and vertical

closable for tools with internal coolant supply

Hinged mounting device for toolholders

Exchangeable carbide tipped scriber

B showing the deviation of each block