Plastic piping systems for soil and waste discharge (low and high temperature) within the building structure. Polypropylene (PP) - Guidance for the assessment of conformity1 Scope This document gives guidance for the assessment of conformity of materials, products, joints and assemblies in accordance with the applicable part(s) of EN 1451 intended to be included in the manufacturers quality plan as part of the quality management system and for the establishment of third party certification procedures. NOTE 1 The quality management system is expected to conform to or is no less stringent than the relevant requirements to

BS EN 13476-3 is applicable to:

the method in ISO 787-22 has been established because it is essentially a practical test and as such is probably of greater general value than other methods

but rather to be general in nature and applicable to all methods of manufacture

New informative Annex G for the determination of the adhesive strength of the tape on the test surface

ISO 18806 provides guidance for carrying out test methods such as- High temperature combustion and high-pressure vessel combustion with precision and accuracy

BS EN 61360‑1 specifies principles for the definition of the properties and associated attributes and explains the methods for representing verbally defined concepts with appropriate data constructs available from IEC 61360-2

It does not address regulatory or legal requirements

This is applicable when it is agreed that the standard is deficient in some way

and specific technical requirements of fault protection and dynamic control

For each view

stairs and modular tiles and paving units (slabs

5) xi u Ui