Projection Design F1+-SXGA+-(300w) Replacement Projector Lamp With Original Bulb InsideBring your Projection Design F1+ SXGA+ back to full brightness with this original 300 watt replacement lamp and housing. The genuine OEM bulb restores clean, even light for home theater and installation use, with about 2,000 hours of rated life. The complete module is factory assembled for a straightforward swap. Fits: Projection Design F1+ SXGA+ (300w).

Light up large venues again with this original 113-628C replacement lamp and housing for Digital Projection projectors

making it suitable for various ducts and plenums

easy-to-install solution for tight spaces

Nominal capacity: 19

The sensor element combines an Invar rod with a seamless brass tube (11/32 inch diameter x 18-3/4 inch length) and a remote bulb

Operating in temperatures from -40 to 150 degrees Fahrenheit

creating consistent heat output and reduced maintenance over time

Gas Fired Unit Heater Transformer for Modine systems: the Modine 5H71956-1 is designed for PD30/PD100/PD150/PD200 gas-fired unit heaters and delivers reliable power for safe

this six-wire harness minimizes impedance while preserving signal fidelity across control lines

NP-PH1000UJD NEC Projector Lamp Replacement

with end connections that are male-threaded x female-threaded to fit common piping configurations

factory-tested component designed to maintain airflow sensing accuracy and furnace safety