Morse taper adaptor SK 40 - 4 - 156Application: For mounting tools with Morse taper shank and tang according to DIN 228 1 form B. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

High holding forces: increase by a factor of 3 to 5 compared to standard jaws

For the storage of collets

Designed for the measurement of intricate internal characteristics

Especially in operations in toolmaking and mould making

Horizontal und vertikal aufspannbar

Battery :1

stress-relieved and precision ground

With clamping screw and O-ring

Clamping possible on both sides

because only the shaft diameters and the squares must fit

and vertical

no adhesion occurs and the tool