Textile machinery. Dyeing and finishing machines. Designation of operating ranges of component parts1 Scope This Standard gives designations for the recommended operating ranges for component parts of dyeing and finishing machines. The parts covered are those which operate under dry or wet conditions or in steam, and which either come into contact with the fabric or are positioned within 100 mm of the fabric.

and widely referenced

BS EN 312-7

Addition of austenitic-ferritic (duplex) grades 1

ISO/IEC 17000:2004

secondary cells and batteries

Financial invoice financialInvoiceV01 message

What is BS 3238-1 - Graphical symbols for servo-mechanisms about

Mains parts

ferrite determination in austenitic stainless steels

responsible for delivering assessments via IT includingdeveloping or specifying the delivery software

6 g/ml to 2

This document contains also procedures and tests for verification of the compliance with the requirements as well as safety information for use