End mill holder Weldon with cooling channels HSK 100 - 32 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw and O ring All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Instruction manual

Measuring contact points are designed to allow measurements near to the bottom of blind holes

Delivery with test certificate All holders are made of forged steel

3 µm radial run-out with a 2 µm clamping nut

Angle reading = 10 arcmin

For mounting straight-shank tools in collet chucks DIN 6391

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

For adaption from SK/ISO to PSC (ISO 7388-1 to ISO 26623-1)

Angle reading and adjustment using a vernier

longer tool life

Made of precision ground hardened stainless steel

With retaining screw