Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Test methods to prove the leaktightness of the wall under short-term internal pressure

this Recommendation | International Standard specifies one algorithm for authentication and key distribution which is based on public key crypto systems

Published Document (PD) 16949 defines the quality management system requirements for automotive related services

Table 3 – Surface dressing – tolerance and accuracy of rate of spread of binder and chippings

Inch based spherical plain bearings are intended for use in fixed or moving parts of the aircraft structure and their control mechanisms

4 Gap between test specimen and yoke

The selection of the requirement class depends on many factors: the properties of the fluid to be conveyed

— to establish common basis for procedures to perform AT

Why should you use BS IEC 60076-21-Standard requirements

BS EN 754-6 is the European Standard document and part of the BS EN 754 series

and to materials unmodified or modified by colorants

“The Community said” - comments made during Community Brainstorm Day and via a discussion portal

5 Significance and use