Hydraulic fluid power. Flange connections with split or one-piece flange clamps and metric or inch screws - Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 1271 Scope This part of ISO 6162 gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four screw, split and one piece flange clamp type tube connectors and hose fittings for use at pressures of 3,5 MPa (35 bar1)) to 35 MPa (350 bar). It also specifies the dimensions of the seals to be used, as well as the grooves that house the

Identification of stakeholders and concerns

BS EN 14491 covers:

including sensitivity

BS EN IEC 60076-11 may be applied as a whole or in parts

Using BS EN 1968 guidelines helps with high quality

but may also be used in other applications

actuators and the operator interface)

it will be used by:

BS EN 1011-3 on arc welding of stainless steels applicable to:

for use with tubular fluorescent lamps on supply voltages not exceeding 1 000 V

in order to improve the quality of exhaust gas measurements

however there is a need for further verification (see Annex D)