C123E-250 Locking AssemblySingle taper, self centering design without mounting flange for use in through bored components. Mounted component moves axially during installation. View Catalog PageInstallation & Removal Instructions

Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor

Clamping coupling portion will not mar the shaft

Traditional cost effective rigid coupling design provides torque transmission and alignment

Design fully engages the thread for secure locking

Interchangeable with most metal units

Recessed screw head provides safety with an outside surface free of major projections

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

Climax Series C801 Single Nut Locking Assemblies deliver a mechanical interference fit and provides a higher torque capacity over alternative keyed connections

Allows you room to re-bore the ID without damaging the clamp screws

oil resistant rubber liner which corrects up to 2° misalignment while reducing vibration & noise

self-centering design without mounting flange for use in through-bored components

These unique two-piece rigid clamping couplings come with an undersized ID