Flat products made of steels for pressure purposes - Weldable fine grain steels, thermomechanically rolled1 Scope This European Standard specifies the requirements for flat products for pressure equipment made of weldable fine grain thermomechanically rolled steels as specified in Table 1. The steels are not suitable for hot forming. NOTE 1 At the time of publication of this European Standard, no sufficient data for the standardization of the elevated temperature properties of these steels was available. If their use at such temperatures is intended the

otherwise the default class of material may be supplied

BS 5315 specifies the requirements for worm drive hose clamps for general purpose use in the size range commencing at 12 mm

Manufacturers of sealants

BS EN 14187-4 will help you to manufacture sealants that are resistant to the chemicals

Note: BS 1702 does not apply to the special drums required for the storage and conveyance of the following liquids such as carbon disulphide and any liquid not complying with the pressure test

BS EN 50332-1 on maximum sound pressure level measurement of headphones is useful for:

authentication and non-repudiation of stored data

Their critical application makes uniform and consistent high-quality production a necessity

5 What to achieve and why

sub-layers or any other material integrated at the underside of the floor-covering element are not included in the test and should therefore be removed before testing

BS EN 12674-4 specifies minimum levels of performance for critical tests

BS EN 12963 can help in conducting tests to determine the free monomer content in adhesives based on synthetic polymers