Manipulating industrial robots. Mechanical interfaces - Plates1 Scope This part of ISO 9409 defines the main dimensions, designation and marking for a circular plate as mechanical interface. It is intended to ensure the exchangeability and to keep the orientation of hand mounted end effectors. This part of ISO 9409 does not define other requirements of the end effector coupling device. This part of ISO 9409 does not contain any correlation of load carrying ranges, as it is expected that the appropriate interface

8 Switch-off and electrical isolatio

BS EN 15651-5 is the fifth part of the BS EN 15651 series of documents that specifies procedures for assessment and verification of constancy of performance

cyanogen iodide-treated or preserved samples may be analysed directly

This part of ISO/IEC 80000 encompasses quantities and units for physiological

LEDs (Light and motion systems

IEC 61508-4:1998

The calibration procedure of the furnace wall temperature has been adjusted

BS EN 62435-2 is a document for long-term storage of electronic devices drawing on the best long-term storage practices currently known

It is essential to fully document and follow the items listed in clause 3

It applies to shafts that link tractors or other self-propelled machinery to the first fixed bearing of recipient machinery

you can be ensured of 100-GHz spectrum measurement equipment

type of specimen