Standard Guide for Three Methods of Assessing Buried Steel Tanks

The purpose of BS EN 60793-1-53 is to define a test that determines the suitability of sub-category A1a to A1d multimode fibres and class B and C single-mode fibres to withstand the environmental condition of immersion in distilled or demineralized water which may occur in actual use

The setting is the process of transition from plastic to a solid state characterised by the initial and final penetration times

This standard applies to compartments pressurized at a maximum pressure of 3 bar (gauge) and with a maximum product pressure × volume of 2 000 bar litres with inert gases

and testing requirements for full-locked coil hoists and half-locked and full-locked coil guide ropes for mine shafts

BS 3900-D8 provides colorimetric terms and fundamental requirements for determining the colour and the colour difference of the paint

— Part 2 defines the process implementation requirements for a terminology management system and for a Registration Authority with a digital annex

BS EN 285 was fully revised

What is BS EN ISO/IEC 17665:2006

competent authorities involved in the planning process in the UK

nor does it cover the performance of pipes as regards clogging

recommended performance

and range of recommended test levels for equipment about unidirectional surges caused by over-voltages from switching and lightning transients