Implants for surgery. Wear of total hip-joint prostheses - Testing hip prostheses under variations in component positioning which results in direct edge loading1 Scope This document specifies the test conditions to simulate edge loading in hip prostheses due to steep acetabular cup inclination angle and dynamic separation conditions. This document is used in conjunction with ISO 142421 or ISO 142423.

The control aspects of Shewhart-type variables charts for mean

BS EN 2076-3 provides you with guidelines for casting development as well as pre-production castings

BS EN 13032-1:2004+A1 is part 1 of a multi part standard

BS 9251 thus aims to extinguish small fires or contain growing fires until the fire and rescue service arrives by reducing the rate of heat and smoke generated

The Scope covers conformance testing (and approval) of new engineering developments

closed respiratory gas systems

providing examples of the typical forms used

This British Standard provides for four grades as follows:

This guide concerns all programmes

It can be used on equipment for ground support equipment

BS EN 50090-1 intended to be used electronic devices linked via a digital transmission network to provide automated

BS EN 764-2 consists of seven parts which are: