Shrink chuck 3° HSK 63 - 05 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Metallic sealed for mounting straight-shank tools with coolant-through in collet chucks ISO 15488 (ex

00005" / 0

With drivers

Coolant nozzles lockable for tools with internal coolant

Axial sealed with two O-rings

Ground internally and externally

Ausführung:

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

Bolt and Holding ring

clamping depth

Clamping screw

thin thread and pitch diameter oversize