End mill holder Weldon HSK 50 - 16 - 80Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

parallelism: 0

Further information on the articles included can be found under the respective article number

For retaining screw DIN 6367

Calibration certificate

102 x 38 x 15

Angular accuracy = 10 arcmin

Chrome vanadium steel main body

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

With balanced clamping nut

coolant pipes is screwed to the cylinder head screw integrated in the adapter

Construction: Hardened steel

Adapter / reduction / extension for polygonal hollow shank tapers