Chemical disinfectants and antiseptics. Quantitative suspension test for the evaluation of fungicidal or yeasticidal activity of chemical disinfectants and antiseptics used in the veterinary area. Test method and requirements (phase 2, step 1)1 Scope This European Standard specifies a test method and the minimum requirements for fungicidal or yeasticidal activity of chemical disinfectant and antiseptic products that form a homogeneous, physically stable preparation when diluted with hard water or in the case of ready to use products with water. Products can only be tested at a concentration of 80 % or less, as some dilution is always produced by adding the test organisms and interfering

the requirements in BS 7371‑1:2009 that are applicable to sherardized coatings apply

The standard reuses existing relevant standards where available

flat one layer

irrespective of the material

BS EN 60068-2-31:2008 now incorporates BS EN 60068-2-32:1993

these cables may be suitable for use up to 230/400 Vac in pressurized zones only when installed to take account of possible short circuit effects

BS EN 15593 on food packaging hygiene management system is useful for:

and how to operate the necessary measurement processes

• The general conditions to be met for the approval of connections other than the above mentioned ones

Electromagnetic emission requirements for electrical and electronic apparatus in industrial environments

What is BS EN 16929-Timber floor vibration properties about

recovery and removal situations