Plastics piping systems for non-pressure underground drainage and sewerage. Polyethylene (PE) - Guidance for the assessment of conformity1 Scope This Technical Specification gives guidance for the assessment of conformity of materials, products, joints and assemblies in accordance with the applicable part(s) of EN 12666 intended to be included in the manufacturers quality plan as part of the quality management system and for the establishment of third party certification procedures. NOTE 1 It is recommended that the quality management system conforms to or is no less stringent than the

see Clause 4

it is beyond the scope of this International Standard

This PAS describes a widely applicable approach to achieving trustworthy software

rigid wood-based panel products

One procedure is applicable to the preparation of laboratory sheets using the conventional sheet former and the other using the Rapid-Köthen sheet former

6   Requirements for quality requirements

manufactured by the wet lay-up process

Companies that use vicinity cards for their gateway for security purposes

assembly or system

According to the outcome

including manufacturing retail

BS EN 61077 defines the mechanical parameters and characteristics of the compact VHS videocassette