Adhesives. Designation of main failure patterns1 Scope This International Standard specifies the designations for the main types of failure pattern of bonded assemblies and illustrates, through diagrams, their respective appearances. It applies to all mechanical tests performed on a bonded assembly, regardless of the nature of the adherends and adhesive which make up the assembly.

NOTE: This standard does not apply to multiple meter installations installed in the same housing

Acceptance tests of gas turbines with emission control and/or power augmentation devices that are based on fluid injection and/or inlet air treatment are also covered by this International Standard and it is necessary that they be considered in the test procedure

Note 3: PD IEC/TR 80001-2-2 is intended to act as a basis for discussion and agreement sufficient to initial integration project risk management

This helps in identifying the materials to be used in manufacturing these packages

— terms and definitions for quantifying finger image quality

as defined in ISO/IEC 9646-1

in the case of the study reported in Reference [4]

1) The boiler shell

What is BS EN 20-1- Protective effectiveness against Lyctus brunneus used in wood preservatives about

BS EN 54-24

Piezometric data

such as computer and physical access control