Structural bearings - Inspection and maintenance1 Scope This European Standard applies to the inspection and maintenance of bearings designed in accordance with EN 13371, when used in the construction of bridges or structures requiring similar bearing systems. It presupposes the existence of guidelines for the regular inspection of the whole structure during its service life. It may also be used as appropriate for the inspection and maintenance of bearings designed and or installed before the

change rotational speed

Electronic tachographs help to measure the speed of the car and distance travelled by the car

water-soluble

Read more about EN 15986 on the European Committee for Standardization’s (CEN) website

This part of EN 50117 which is a sectional specification applies to coaxial indoor drop cables for analogue and digital one and two way signal transmission

This PAS will be valuable to food businesses of all sizes and at all points in the food supply chain

BS 3505 classifies PVC-U pressure pipes based on their pressure tolerances

their management

intended to measure the peak level of a digital signal at any desired point of a digital audio signal system

dimensions and marking of covered metal jacketed gaskets for use with flanges complying with prEN 1759‑1 for Class 150

definitions and service expectations for market

Note: BS EN 14701‑4 gives a method that is also applicable to sludge suspensions from other origins