Rubber, vulcanized or thermoplastic. Determination of hardness - Hardness between 10 IRHD and 100 IRHD1 Scope This document specifies four methods for the determination of the hardness of vulcanized or thermoplastic rubbers on flat surfaces (standard hardness methods) and four methods for the determination of the apparent hardness of curved surfaces (apparent hardness methods). The hardness is expressed in international rubber hardness degrees (IRHD). The methods cover the hardness range from 10 IRHD to 100 IRHD. These methods differ primarily in the

EN 50525‑2‑22 applies to crosslinked EPR insulated and textile braided flexible cables

or hydrogen embrittlement of metallic and other inorganic coatings

explosives which do not require atmospheric oxygen for combustion

Because the appearance and serviceability of electroplated cadmium coatings are influenced by the surface condition of the basis metal

This International Standard describes a method for the determination of the scattering of light by contact lenses

It specifies the acoustical and operational requirements which are to be agreed upon between the supplier or manufacturer and the user of a silencer

Optional command set (design dependant)

ingredients

7 Control system

and can be assessed where loss of material due

or amorphous silicon specimens with boron atomic concentrations between 1 × 1016 atoms/cm3 and 1 × 1020 atoms/cm3

The method specified in this part of ISO 4869 is not applicable as the basic test for type approval