LS1 Crank Sensor Extension HarnessIn some conversions with block hugging headers, the crank sensor branch is prone to extreme heat which can damage or melt the wiring. These extensions plug into the existing wiring and allow you to run the crank branch along the valley, down the front of the cylinder head and to the crank angle sensor. Uses genuine Delphi connectors, seals 7 terminals and heat rated TXL wire. Default length is 1m, if you require a custom length please let us know.

Suits: iC-7 Mounting Brackets (HT-060070 and HT-060071)

Glide etc) and Manual transmission

- LS1/2/3 Evaporation Canister Purge Valve

EXTENDING OR REPAIRING WIRING

Cruise Control (On request)

- 5x Seals (+1 Spare)

- Oil Temp (If using Factory Sump Sensor)

Includes: 1 x 2

Replacement for the Oil Pressure Sender for the VN-VS Dash

HARNESS OVERVIEW

- VE VF and Late VZ LS2/3 (L77

After a valid crankshaft and camshaft signal (engine rotating) is present the LED will switchto GREEN to indicate that the input signal(s) are valid and the 24x crankshaft and cam sync outputsare active